新聞中心

EEPW首頁 > 嵌入式系統(tǒng) > 設計應用 > 如何通過MAX2990 I2C接口向標準EEPROM (24C04)連接

如何通過MAX2990 I2C接口向標準EEPROM (24C04)連接

作者: 時間:2010-10-25 來源:網絡 收藏

現在,我們可以驗證一下用于讀、寫操作的功能。

本文引用地址:http://m.butianyuan.cn/article/173171.htm
i2c_init_write(void)i2c_init_read(void)i2c_write(UINT8 data)i2c_read(UINT8 *data)

void i2c_init_write(void){CN_bit.MODE = 0; //  transmit modeI2CCN_bit.I2CACK = 1; // Creates I2C NACK so that slave can create ACKI2C_START; 		// Generates I2C START conditionwhile( I2CCN_bit.I2CSTART == 1 ); 	// Waits until the START condition// was put to the I2C busI2CST_bit.I2CSRI = 0; 		// Resets the I2C interrupt flag}int i2c_init_read(void){I2CCN_bit.I2CMODE = 1; 	// I2C read-modeI2CCN_bit.I2CACK = 0; 	// Creates I2C ACK after receiveI2C_START; 		// Generates I2C START conditionwhile( I2CCN_bit.I2CSTART == 1 ); 	// Waits until the START conditionI2CST_bit.I2CSRI = 0; 		// Resets the I2C interrupt flag}void i2c_write(UINT8 data){I2CBUF = data; 			// Puts the data on the I2C buswhile( I2CST_bit.I2CTXI == 0 ); 	// Waits for transfer completeI2CST_bit.I2CTXI = 0; 		// Resets the I2C transmit complete// interrupt flag}void i2c_read(UINT8 *data){I2CBUF = 0xff; 	// Puts all ones on the I2C bus so that slave can pull// the bus down to generate zeroswhile( !I2CST_bit.I2CRXI ); 		// Waits for receive completeI2CST_bit.I2CRXI=0; 		// Resets the I2C receive complete// interrupt flag*data = I2CBUF; 			// Writes the data to the pointer}

上一頁 1 2 下一頁

評論


相關推薦

技術專區(qū)

關閉