新聞中心

EEPW首頁 > 模擬技術 > 設計應用 > 在16位、100kSPS數據采集系統中實現低功耗和高性能

在16位、100kSPS數據采集系統中實現低功耗和高性能

作者： 時間：2013-10-16 來源：網絡 收藏
rgb(0,0,0); TEXT-INDENT: 0px; PADDING-TOP: 0px; WHITE-SPACE: normal; LETTER-SPACING: normal; webkit-text-size-adjust: auto; orphans: 2; widows: 2; webkit-text-stroke-width: 0px">PC with USB port， USB cable， and installed 10-lead PulSAR software

Setup and Test

The block diagram of the ac performance measurement setup is shown in Figure 9. Connect the 2.5 V and 4 V power supply to the evaluation board power terminal.

To measure the frequency response， connect the equipment as shown in Figure 9. Set the Audio Precision SYS-2522 signal generator for a 10 kHz frequency and a 2.5 V p-p sine wave with a 1.25 V dc offset. Record the data using the evaluation board software.

The software analysis is part of the evaluation board software that allows the user to capture and analyze ac and dc performance.

在16位、100kSPS數據采集系統中實現低功耗和高性能

Figure 9. Circuit Test Setup for Measuring AC Performance
上一頁 1 2 3 4 下一頁

評論


相關推薦

技術專區

關閉