新聞中心

EEPW首頁 > 電源與新能源 > 設計應用 > OnSemiNCV8855多輸出電源控制解決方案

OnSemiNCV8855多輸出電源控制解決方案

作者: 時間:2012-07-30 來源:網絡 收藏
On Semi公司的NCV8855是集成了高邊負載開關的多輸出電源控制器/穩壓器,能滿足汽車無線系統和儀表盤電源的要求. NCV8855還集成了(SMPS)降壓控制器,2.5A SMPS降壓穩壓器和兩個低壓降(LDO)線性穩壓器控制器,和超低靜態電流的NCV861x一起能組成8輸出的無線系統或儀表盤電源解決方案.器件滿足ES?XW7T?1A278?AB測試脈沖G負載條件,VIN工作電壓9.0V-18.0V.本文介紹了NCV8855主要特性, 應用電路/方框圖, 汽車無線電系統框圖以及NCV8855評估板電路圖與材料清單.

The NCV8855 is a multiple output controller / regulator IC with an integrated high?side load switch. The NCV8855 addresses automotive radio system and instrument cluster power supply requirements. In addition to the high?side load switch, the NCV8855 includes a switch?mode power supply (SMPS) buck controller, a 2.5 A SMPS buck regulator and two low dropout (LDO) linear regulator controllers. The NCV8855 in combination with the ultra?low quiescent current NCV861x IC forms an eight?output automotive radio or instrument cluster power solution. The NCV8855 has an internally set switching frequency of 170 kHz, with a SYNC pin for external frequency synchronization.

The NCV8855 is intended to supply power to various loads, such as a tuner, CD logic, audio processor and CD / tape control within a car radio. The high?side switch can be used for a CD / tape mechanism or switching an electrically?powered antenna or display unit. In an instrument cluster application, the NCV8855 can be used to power graphics display, flash memory and CAN transceivers. In addition, the high?side switch can be used to limit power to a TFT display during a battery over?voltage condition.

NCV8855主要特性:

? 1 uA Shutdown Current

? Meets ES?XW7T?1A278?AB Test Pulse G – Loaded Conditions

? VIN Operating Range 9.0 to 18.0 V

? 1 SMPS Controller with Adjustable Current Limit

? 1 SMPS Regulator with Internal 300 m NMOS Switch

? 2 LDO Controllers with Current Limit and Short Circuit Protection

? 1 High?side Load Switch with Internal 300 m NMOS FET

? Adjustable Output Voltage for All Controllers / Regulators

? 800 mV, +/-1% Reference Voltage

? System Enable Pin

? Single Enable Pin for Both LDO Controllers

? Independent Enable for High?side Load Switch

? Thermal Shutdown with Thermal Warning Indicator

? This is a Pb?Free Device

NCV8855應用:

? Automotive Radio

? Instrument Cluster, Driver Information System (DIS)

圖1. NCV8855應用電路/方框圖

圖2. NCV8855和NCV8612汽車無線電系統框圖
NCV8855評估板

圖3.評估板NCV8855BMNR2GEV外形圖

圖4.評估板NCV8855BMNR2GEV電路圖
評估板NCV8855BMNR2GEV材料清單:






詳情請見:
http://www.onsemi.cn/pub_link/Collateral/EVBUM2120-D.PDF

http://www.onsemi.cn/pub_link/Collateral/NCV8855BMNR2GEVB_SCHEMATIC.PDF


評論


相關推薦

技術專區

關閉