新聞中心

EEPW首頁 > 嵌入式系統 > 設計應用 > 串行通信UART和PROTEUS仿真設計

串行通信UART和PROTEUS仿真設計

作者: 時間:2012-01-10 來源:網絡 收藏

本文引用地址:http://m.butianyuan.cn/article/172242.htm

atmega64的程序:

兩個文件,一個是將函數模塊化,別一個是主函數,調用(- -!最近習慣將程序模塊化。。。)

//------------------uart.c---------------------

//----這里將函數模塊化------------

#include iom64v.h>

void uart0_init(void)
{
UCSR0B = 0x00; //disable while setting baud rate
UCSR0A = 0x00;
UCSR0C = 0x06;
UBRR0L = 0x33; //set baud rate lo
UBRR0H = 0x00; //set baud rate hi
UCSR0B = 0x18;
}


void uart0_Transmit( unsigned char da
ta )
{
/* Wait for empty transmit buffer */
while ( !( UCSR0A (1UDRE0)) )
;
/* Copy ninth bit to TXB8 */
UCSR0B = ~(1TXB80);
//if ( da
ta 0x0100 )
//UCSR0B |= (1TXB80);
/* Put da
ta into buffer, sends the data */
UDR0 = da
ta;
}

unsigned char uart0_Receive( void )
{
/* 等待接收數據*/
while ( !(UCSR0A (1RXC0)) )
;
/* 從緩沖器中獲取并返回?cái)?shù)據*/
return UDR0;
}

//--------------main.c-----------

//--------------------------------

#include iom64v.h>
#include spi.h
#define commun_symbol 0x31

//-----------send a commun_symbol-----
//-----------receive a commun_symbol--
// --no,continue receive||||||yes-->receive the da
ta and send
void main()
{
unsigned char bybuff;
DDRB=0xff;
PORTB=0xff;
uart0_init();
{

do
{
bybuff=uart0_Receive();
}
while (bybuff!=commun_symbol);//commun_symbol);
while(1)
{

uart0_Transmit(bybuff);
bybuff=uart0_Receive();
PORTB=(0xff|bybuff);
}
}
}

ok,任務完成了,改天實驗一下!


上一頁 1 2 下一頁

評論


相關推薦

技術專區

關閉